Rate Card
Rate Card
Session fees cover bench time and the written record. Components are billed separately at what they cost us plus a flat build charge, and the invoice itemises both.
Single Club
$115 Per session, 60 to 90 minutes- One club category: driver, fairway, hybrid, wedge or putter
- Audit of the matching club you already own
- Component trials from the rack, no upcharge
- Written build record with as-ordered targets
- Fee credited against a build placed within 30 days
Most booked
Iron Set
$210 Per session, about two hours- Full iron set including the gapping table
- Turf interaction work before any launch numbers
- Lie angle confirmed off the board, not estimated
- Full audit of the set you walked in with
- Written record per club, not one sheet for the set
- Fee credited against a build placed within 30 days
Whole Bag
$390 Per session, three hours with a break- Driver through putter in one sitting
- Carry medians measured and gaps mapped end to end
- Recommendations ranked by cost per shot saved
- Written record for every club in the bag
- Second visit within 90 days at no charge
- Fee credited against a build placed within 60 days
Bench labour
Work Without a Session
Plenty of visits do not need a fitting at all. These are the flat rates for bench work on clubs you already own, whoever built them.
| Job | Rate | Turnaround |
|---|---|---|
| Regrip, per club | $6 labour | While you wait |
| Loft or lie adjustment, per club | $9 | While you wait |
| Full set audit, measured and written up | $45 | Same day |
| Shaft pull and reinstall, per club | $28 | Two working days |
| Length change with swingweight correction | $24 | Two working days |
| Single club build from supplied parts | $35 | Five working days |
| Iron set build, per club | $28 | Five to eight working days |
| Ferrule turn and refinish, per club | $11 | Two working days |
| Frequency match an existing set | $85 | Three working days |
| Re-check of anything we built | No charge | While you wait |
Components at cost plus build. We do not mark up heads, shafts or grips beyond
what we pay, and the build charge above is the same whichever component you choose. That removes
any incentive for us to steer you toward an expensive shaft.
What the Fee Actually Buys
Bench time, the rack, and the paperwork. Nothing in a session is held back for an upsell: every shaft on the wall is available to test, and the audit of your current bag happens whether or not you are likely to buy.
- One player in the bay at a time, no shared sessions
- Unlimited component swaps within the booked window
- The written record, printed and signed, even if you buy nothing
- A copy kept on file so a replacement years later still matches
Paying and Cancelling
Session fees are taken at the counter when you arrive, not in advance. Builds are half down when the parts are ordered and the balance when you collect.
- Cards and cash accepted, no surcharge on either
- Cancel or move a session up to 24 hours ahead at no cost
- Deposits on ordered components are refundable until the parts ship
- A build that misses our tolerance window is redone at our expense